• tal@lemmy.today
    link
    fedilink
    English
    arrow-up
    36
    arrow-down
    1
    ·
    2 months ago

    Molex connectors were almost universally hated for being flimsy and requiring a lot of effort to connect properly. They were fortunately replaced by SATA connectors.

    I can understand the “lot of effort”, but flimsy? Those things were built like a tank. SATA connectors certainly aren’t more-durable (not that that normally matters, inside a case).

    • lazynooblet@lazysoci.al
      link
      fedilink
      English
      arrow-up
      22
      arrow-down
      1
      ·
      edit-2
      2 months ago

      Yes they were flimsy. When pushing them together the crimped ends would get pushed out the back of the plastic connector casing. Or they wouldn’t align properly and would require either major force or fiddly realignment.

    • extremeboredom@lemmy.world
      link
      fedilink
      English
      arrow-up
      13
      ·
      2 months ago

      I remember instances where the force required to disconnect the connector caused me to slip and rip a wire out.

    • Dave.@aussie.zone
      link
      fedilink
      English
      arrow-up
      8
      ·
      edit-2
      2 months ago

      They also came from a time when hard drives could draw several amps while in use and much more on spin-up. There was a good reason why SCSI drive arrays used to spin each disk up one-by-one.

      Molex connectors are good for 10 amps or so, SATA connectors couldn’t have handled that amount of current.

    • TheGrandNagus@lemmy.world
      link
      fedilink
      English
      arrow-up
      6
      arrow-down
      2
      ·
      edit-2
      2 months ago

      I have seen so many flimsy molex connectors. SATA was far, far, far more robust. They were enormously flimsy. Are you thinking of the right connector?