Yeah I’m fine with copying prints via sd card, and that’s what I’m doing for the moment. A1 mini came very fast and I just did the tug boat classic first print

Awesome, thank you for the insight!

I’m looking at a Sunlu 4 pack of 1kg PLA, would that be fine filament to start with? I matched the diameter with what they sell on bambu lab.

Ugh I didn’t even think about that, the data collecting. After some research I think I should be able to mitigate that with lan only mode or just some firewall rules or pihole blocking. Thank you for the link!

I was looking at the sunlu s1 and s2 for a filament dryer. The s2 sounds kinda glitchy but functional, and the biggest complaint of the s1 seems to be the 55C max temp.

If my humidity is usually 20% or lower where I live is it likely I can just skip a filament dryer for now?

Digging deeper into the comments it seems someone found the message was from a compromised polyfill code that was running on IA. Now the website is down from a ddos. From what I can see there’s no reason to believe their servers and the data therein have been compromised.

Have you not seen the literally cans of oxygen they now sell? I see them every time I go to my pharmacy

Luke lived on a desert planet, of course he’s warm!

It sounds like a YouTube clone from the article, so long form videos storage and streaming isn’t cheap, a lot more expensive than what x usually hosts in terms of bandwidth and storage per views. But yeah also seems like a niche use case.

Still no way there’s a net cost benefit to video hosting from as revenue.

Video hosting in general is not profitable, this is almost certainly not gonna do anything to help Twitter survive, hopefully they’ll shoot themselves in foot even more.

Yeah, my feelings exactly

Block js had the same issues -.-

Yes that is absolutely perfect. Ty for the link!

Haven’t used 12ft in a minute but it kinda just broke the article for me. Css was overlaying text and it still faded out before the end of the article. Back to block js for me