Assuming it’s due to corrosion, am I correct that that whole section of exhaust should be replaced? I usually source my parts myself if I can. Any recommendations or things to avoid?
Assuming it’s due to corrosion, am I correct that that whole section of exhaust should be replaced? I usually source my parts myself if I can. Any recommendations or things to avoid?
I was completely wrong when I looked yesterday. I don’t think it s as bad.
That’s not a catalytic converter that’s just a resonator (or possibly muffler) to set the exhaust tone. A cat is further up toward the engine and has O2 sensors before and after it. You can probably just clamp it for a while but the proper fix is to have a new resonator/muffler put in or have it cut out and replaced with a section of pipe.
You can probably weld or jerry rig this together with clamps, but you should probably replace. Unfortunate it looks like Toyota designed it to be one pipe - sometimes these are separate pieces that are cheaper and easier to replace.
A piece of stainless steel or aluminum duct and a few hose clamps will hold this together long enough for you to forget that you rigged it when it breaks again and you actually have to replace something.
You might be able to get away with cutting out a section and clamping a new piece on.
If you do please check that there isn’t an exhaust leak.
That’s well fixable. I got a stainless steel toilet brush holder and cut a cylinder out of it, cut it down lengthways and wrap it round, with some GunGum underneath. Four heavy duty jubilee clips to hold it in place.
Lasted for about 5 years on a MK5 Transit
Yeah thats broke
Either clean up and attempt to weld a sleeve or get a new exhaust from the cat back